CONFIGURATION OF HYPER TERMINAL

                                           Configure Hyper-Terminal

Steps to configure Hyper Terminal

Click   Start -> Programs -> Accessories -> Communication -> Hyper Terminal

HyperTerminal will open a dialog box, give a name (user defined) and click “ok”

Select the "COM" port to which the console cable is connected and click "ok"

Click on “Restore Defaults” and click “OK”

Default values are:-

Bits per second:         9600

Data Bits:                    8

Parity:                         None

Stop Bits:                    1

Flow Control:             None

Once Hyper Terminal is ready, now switch on Router.

After the Router boots-up completely, (on a new Cisco Router) it displays the following question:

            ------System Configration Dialog------

Would you like to enter the initial configuration dialog? [Yes|No]:       No

Would you like to terminate autoinstall? [Yes]:

If you choose “yes” IOS will prompt Questions to gather the information to configure the Router, it is recommended to choose “no”, since we can configure the Router using IOS commands.